clage GERMAN POOL GPIM7, Operating Instructions Manual

Page: 8 / 40

8 9
Fill the appliance completely with water by repeatedly opening and closing the hot­water tap
before connecting to electrical power. The heating element may be damaged if this is not
done!
• The installation must comply with current IEC regulations and national local regulations and any par -
ticular regulation, specified by the local electricity supply company!
• The mains cable must be permanently connected via connecting box as shown in the circuit diagram.
The earth conductor must be connected.
• A circuit breaker in accordance with IEC with a contact opening gap of at least 3 mm for each pole
must be provided on the mains side of the connecting box.
• The wiring must be done with CCC approved 4 mm 2 power cable only. The wiring cross-section must
be well adapted to the corresponding power rating. See technical data.
• To protect the appliance, a fuse element must be fitted with a tripping current commensurate with the
nominal current of the appliance.
• Check that the power supply is switched off prior to electrical connection.
Abb. 6 Schaltplan
1 Elektronische Regelung
2 Heizelement
3 Sicherheitstemperaturbegrenzer
fig. 6 Circuit diagram
1 Electronic regulator
2 Heating element
3 Safety thermal cut-out
PE N L (220V~)
Q
<
<
8. Electrical connection