Clack T.F.C.-400, Installation, Operation & Service Manual

Page: 7 / 20

7
4. Place the Base Assembly through the
mounting hole on the sink or counter top.
Drop the handle of the Wrench through the
Faucet Base opening. This will separate and
orient the Toggle Wings. Position the Faucet
Base so that the arrows are pointing in the
direction that the faucet handle will face.
Tighten the 1/8” Screws with a Phillips
screwdriver. When the Toggle Wings make
contact with the mounting surface, adjust the
Faucet Base to the exact desired position.
Tighten the 1/8” Screws an additional 2 –3
turns while holding the Faucet Base in place.
TAB
HOSE BARBS
3/8” QUICK
CONNECT FITTING
BLACK 3/8” POLYTUBE
(TO DRAIN CLAMP)
BLACK 1/4” POLYTUBE
(TO DRAIN PORT
ON RO SYSTEM)
BLUE 3/8” POLYTUBE
(PRODUCT OUTLET)
5. Connect the tubing to the Faucet. Push
the Blue 3/8” Polytube into the 3/8” Quick
Connect Fitting. Push the Black 3/8” Polytube
onto the large Hose Barb. Push the Black ¼”
Polytube onto the small Hose Barb.
6. Determine which direction the handle
should face (right or left). As shown, it can
be mounted in two directions. With the
handle facing the chosen direction, slide
the fastened Polytubes through the Faucet
Base and slide the Faucet Assembly into the
Faucet Base, lining up the tabs on the Faucet
with the slots on the Base. The Faucet
Assembly may have to rotate slightly to get
the tabs into the slots. When aligned, apply
firm downward pressure to get the Faucet
to fully seat. After the Faucet Assembly
is seated, lock it into place by rotating it
clockwise about 30 degrees.