Claas LEXION 7000, Information And Basic Field Settings

Page: 32 / 62

Check the height:
Check the height of the auger within
the trough of the cutterbar. There
should be a minimum gap of 20mm
between the trough and the auger
flights.
Retractable fingers:
Remove the intermediate retractable
fingers along the length of the auger
leaving just the middle ones.
Sprockets:
In exceptional wrapping conditions,
the speed of the auger can be
slowed by optional sprockets on the
chain drive shaft. With the split reel
cutterbar, two sets of sprockets
are required.
Retractable fingers:
Lift the skids as high as possible to
get as much movement for the sensor
bands. The skids underneath the
cutterbar should be set to suit the
local conditions.
Settings: VARIO Cutterbar adjustments
31