[SM-200164-A/4]
−
32
−
MAINTENANCE
６
6.2.2 Assembly and Disassembly
1) Assembly of the block manifold
(1) Secure the DIN rail.
(2) Set on the rail the end blocks, air supply / exhaust blocks, and the valve
blocks in necessary numbers and connect them with the keys.
(3) Tighten the screws of the end blocks at both sides end fix them to the rail.
(4) Mount the solenoid valve on the valve block (the solenoid valve is attched to
the valve block upon shipment).
(5) Connect the tubes and wires to complete the assembly.
2) End block mounting
(1) First confirm that the fixing screws are loose. Push the block from above
and get the movable claw hooked onto the rail.
(2) Lift the block to see the claw is firmly in place.
(3) Tighten the two screws, at the torque of 0.9 N
・
m, after all the other blocks
are set.
3) End block detaching
(1) Turn the screws six to seven times to loosen
them and pull out the connecting key.
(2) Slide the end block 4mm or more and pull it
out in the direction indicated by the arrow in
the drawing.
Air supply / exhaust block
End block
Valve block with solenoid valve
Partition block
Air supply / exhaust block
Fixed claw
End block
Movable claw
Valve block with solenoid valve
DIN rail
Mounting screw
Connecting key
