8
installation:
fitting and threading the filler Wire:
caUtion:
do not feed wire through the drive rolls under pressure.
keep hands away from the wire guide end while feeding
the wire through the feed cable.
When using soft aluminum wire, it may be necessary to
unscrew the compression nut fastening the feed tube to
the wire guide, and manually feed the wire through the
wire guide.
caUtion:
note:
6.
remove the right side Wire feed Unit cover and install a spool of welding wire. drive
rolls have two grooves. check the feed roll to be sure it is on the correct side for the
filler wire being used. see page 21 for drive roll sizes. Unlatch and raise the pressure
roll arm. thread the wire through the inlet guide to the drive rolls. feed the wire across
the drive roll groove and into the feed cable inlet guide. close and relatch the pressure
roll arm.
7.
after the wire has been started into the feed cable, straighten feed cable and feed wire
under power by actuating the torch switch. keep the feed cable as straight as possible
and continue pushing the switch until the wire has completely fed through.
feed cable inlet guide
drive roll
inlet guide
pressure roll
pressure roll arm
compression nut
feed tube
Wire guide
compression fitting
