7
checklist:
optional
iteMs:
installation:
Wf5 Wire feed Unit
cWMes:
cWh:
iteMs reQUired for cold Wire tig Welding not provided:
drive roll set - for wire size and type specified (installed)
torch outfit with feed cable, Wire guide and Wire guide
Bracket - model specified at time of order
remote switch with 11 ft. (3.4m) lead - required for machine torch operation, but
must be ordered as a separate item.
the ck cold Wire tig Wire feed Unit requires 115 volts alternating current to
operate. the 115v MUst be supplied by an isolated, groUnded outlet. do not
connect to the 115v ac outlet on the power source. 220v also available.
1.
attach the water cooled power cable of the tig torch to the electrode terminal on the
power source. a power cable adapter is required to make the proper connection (the
water cooled power cable is the water out line).
2.
attach the ground cable from the power source ground terminal to the work or fixture.
the ground cable should be adequate size and no longer than the torch leads.
3.
attach the torch water in and gas supply hoses to their respective connections points.
4.
plug the feed unit control cord into an isolated, grounded 115v ac outlet. do not con-
nect feed unit control cord into the 115v ac on the welding power source. for feed
units requiring 220v ac, install an appropriate plug. then plug the feed unit control cord
into an isolated, grounded 220v ac outlet.
5.
do not set the cold Wire feeder directly on the power supply without an insulating
barrier.
hand held feed assembly and remote switch with 8 ft. (2.4m) feed cable for soft
wire, 10 ft. (3m) feed cable for hard wire.
1. Welding power source - suitable for tig welding.
2. Water recirculator - for cooling welding torch.
3. regulator / flowmeter - for control of shielding gas flows.
4. shielding gas and cylinders.
5. full cover welding helmet with proper shaded lens.
6. leather welding gloves.
7. 12” (30.5cm) spool of welding wire.
8. ground cable - sized to suit current range - and ground clamp.
