3.
Use at least one wire tie to secure
the scroller to the lighting fixture
(Example 8)
. The scroller must
not be able to shift in the gel
frame holder; Shifting may result
in AutoYoke inaccuracy and the scroller
falling from the fixture.
3-5
INSERTING THE AUTOIRIS
The AutoIris is an optional accessory. See Section 6 for further information.
***Note: It is extremely important to avoid damaging the AutoIris with the end of the lens tube while it
is in the fixture. This can occur while focusing the lighting fixture if the lens tube is forced all
the way in. Damage can also occur if the AutoYoke is shipped with a loose lens tube allowing
the tube to slam into the AutoIris.
1.
Remove iris slot cover from lighting
fixture and keep the screws.
2.
Rotate iris slot cover 180 degrees and
hold in place.
3.
Insert the AutoIris into the drop-in iris
slot on the lighting fixture.
4.
Replace screws through holes to retain
AutoIris and reversed iris slot cover.
5.
Plug the DMX Iris signal cable into the
7-Pin female XLR on the AutoYoke
cradle connector box.
-11-
iris slot cover screws
Old position of iris slot cover
New position of iris slot cover
AutoIris
EXAMPLE 8