
E-scooter CITY BOSS R3
ENGLISH
40
13. Regularly check the wear and tear of the product. Replace worn parts immediately.
14. Keep the instructions in the User manual for maintenance and use. Do not disassemble the
device yourself.
15. Check the battery status before each trip. If it is low charged, do not start the trip.
16. The device is for personal use only. Commercial use is not allowed.
17. When riding on uneven surface, keep your legs relaxed and your knees slightly bent.
18. Other activities (making calls, listening to music) can significantly reduce your driving
attention.
19. Do not exceed max. weight.
BEFORE THE FIRST TRIP
Before the first trip, check / adjust:
Front light
The front light is not factory mounted to a scooter for transport safety reasons. Screw it to the
frame, set it to the correct position, and tighten the fixing bolt.
Brake lever
Position the brake lever to be convenient for holding and tighten the brake clamp.
Display
Loosen the fixing bolts of the display clamp and rotate the display so that it is clearly visible and
the throttle lever is handy. Then tighten the fixing bolts again. Remove the protective film from
the display.
Quick-release clamp
The quick-release clamp on the handlebar rod should be adjusted to put a resistance at the
closing and to prevent the handlebar rod to slide downwards when pressed from the top. If the
clamp is too loose, open it, tighten the nut on the screw axis and close the clamp.
Brake
The brake is factory adjusted. If you do not like the settings of the mechanical (drum) brake,
you can adjust it - we recommend adjusting it only after a few rides.
The braking intensity is adjusted by the screw on the brake lever (1) or the brake mechanism
(2). If you loosen the safety nut and unscrew the bolt, the braking rate will be higher and
oppositely. Then tighten the safety nut again (at the brake lever).
Summary of Contents for R3
Page 1: ......