E-scooter CITY BOSS R3
ENGLISH
47
3. Loosen the nuts on the wheel axis. Remember (take a picture) the exact order and placement
of washers on each side of motor axis.
4. Remove carefully the axis and take out the front wheel from the frame.
5. Remove all bolts connecting the rim and take the rim apart.
6. Replace the defective / worn-out tire (inner tube) with a new one.
7. Continue according to the previous steps in reverse order.
8. Inflate the tire to 36 p.s.i. / 2,5 bar.
Lubrication
Oil the folding mechanism of the handlebar every 3 months - do not use WD40 anti-rust oil.
Never lubricate the brake discs.
Brake
Brake pads gradually wear out. The brake can be adjusted after a certain wear - see section
Before the first trip. If the brake pads are worn-out, replace them with new ones - contact your
dealer.
Battery
The battery life time is min. 600 charging cycles. If the worn-out battery is fully charged and yet
you only travel half a distance compared to the new battery, replace the battery with a new
one.
Bolts
Check all parts are secured and the bolts are tightened before every ride.
Do not expose longtermly your e-scooter to the sun, frost or very humid environment. Clean
the e-scooter after use.
GENERAL TROUBLESHOOTING
When the e-scooter is not working properly, check if following work has been completed:
a/ power is turned ON
b/ battery indicator displays sufficient battery capacity
c/ not braked
d/ no error is displayed - see Display operation manual - error messages.
If the above steps are completed and still the e-scooter is not working, contact your dealer.
BATTERY DISPOSAL
Used batteries may not be disposed of as domestic waste. These are classified as chemical
waste and must be disposed of in an environmentally friendly manner. You may place them in
the intended collection bins in shops or dispose of them at KCA (minor chemical waste) depots.
Summary of Contents for R3
Page 1: ......