Citizen iDP-3310, User Manual

Page: 55 / 87

iDP3310 User's Manual
42 CITIZEN
SO
ALL
[Function] Set Double-Width Character or Specify High Page
[Code] <0E>H
[Outline] 1. Serial interface 7-bit setting
High pages are specified in all the modes. If this command is received, the character codes
20H to 7FH are converted into A0H to FFH. This command remains valid until the SI
command or CAN command is received.
2. Serial interface 8-bit setting and parallel interface
This command is ignored in the P-250 mode and P-900R mode. In the other modes, it sets
the double-width characters(same as the RS command <1E>H) and prints the characters
following the command as double-width characters.
If the line has only one character worth of position, printing will be performed in normal
width. This attribute remains valid until the SI command(normal width mode) or CAN
command is received.
In the P-200 mode, this attribute is reset to the normal width at the beginning of each line,
every time the line is fed.
[See Also] RS, US, SI
SI
ALL
[Function] Set Normal Width Character or Reset Character Code
[Code] <0F>H
[Outline] This command resets the double-width character attribute or high page setting and prints in normal
width or normal character code. The print data received after this command is printed in normal
width or normal character code.
[Caution] If double-width character print has been set by the SO command, the same function as the US
command will be assumed.
[See Also] RS, US, SO