Citizen CBM-820, User Manual

Page: 89 / 144

– 74 –
GS r n
n = 1, 49 : Paper sensor status
[Function] Sends Status
[Code] ASCII GS r n
Hexadecimal 1D 72 n
Decimal 29 114 n
[Range] 1 n
2, 49
n 50
[Outline] This command sends the status, depending on setting of n.
[Caution]
• The following tables describe the status sent.
• If DTR/DSR control is selected and the memory switch 4-5 is set to 0, the printer sends only
1 byte after confirming that the host is ready to receive (the DSR signal status is Space).
If the host is not ready (the DSR signal status is Mark), the printer will wait until it will be
ready to receive. If XON/XOFF control is selected or the memory switch 4-5 is set to 1, the
printer will send 1 byte without confirming the DSR signal status.
• Since this command is executed at deployment of the reception buffer, there may be a delay
between command reception and status sending, depending on the reception buffer
condition.
• If ASB is enabled by GS a, it is necessary to distinguish the status by this command from that
of ASB. See “6. Interface” for how to distinguish them.
• If n goes beyond the range, this command will be ignored.
Bit Status Hexadecimal Decimal
0 BOF sensor with paper 00 0
BOF sensor without paper 01 1
1 TOF sensor with paper 00 0
TOF sensor without paper 02 2
2 Undefined – –
3 Undefined – –
4 Unused 00 0
5 Undefined – –
6 Undefined – –
7 Unused 00 0
n Description
1, 49 Sends the paper sensor status. (Same as ESC v)
2, 50 Sends the status of the drawer kick connector. (Same as ESC u 0)