A. Maximum Depth Memory (What is the maximum depth memory)
•
It is the maximum dive depth which is automatically memorized
•
The maximum dive depth is shown by changing over to the maximum depth
memory mode after finishing the dive
•
The maximum depth memory mode is replaced the depth meter mode.
When more than 1m (3ft) of depth is measured, the maximum depth memory mode
is reset and the new value of the maximum depth is memorized
*when the depth valued is under 1m (3ft), the previous maximum depth is
not reset
•
When more than 5M(17ft) of depth value is measured in a second, the value
is deemed as abnormal and not memorized.
How to read the display
The maximum displayed value of the maximum depth memory is 80M (260ft)
The maximum depth memory is displayed as follows:
When the depth value is under 1.0m(3ft), the displayed figure is 0. The
depth value is shown on a 0.1m(1ft) basis when it is over 1.0m (3ft).
When the depth value is over 80m (260ft) it is displayed as --,-(----)
B. Depth Alarm (What is the depth alarm?)
Example
When the diving depth exceeds the previously set
value, a buzzer sounds from 1min to 1min, 10
seconds. The buzzer stops sounding when the diver
goes up towards the water surface beyond the set
value
When the diver goes deeper than the set value,
the buzzer starts sounding again (2).
In addition, if the diver stays at a depth below
the set value for 5 to 6 minutes, the buzzer
starts sounding (3).
•
Display 0,1.0,1.1,1.2,………..80.0,--,--
•
DM Mark -> Depth Memory
•
Display 0,3,4,5,…………… 260,--,--,
Return to Table of Contents
Return to Table of Contents
