Page 46
Air Switch Adjustment
1. Shut off current; disconnect leads and remove air switch.
2. Lay air switch assembly on flat surface. Adjust air
blade at A (figure 1) so that air blade lays flat and
surface B is parallel to the flat surface.
3. Place 3/8 x 5/8 (10 mm x 16 mm) spacer bar or
equivalent C (figure 2) under air blade in position
shown; hold switch mounting bracket firmly and
adjust switch actuator D with needle nose pliers
at E by twisting actuator right or left, whichever
is needed, so that switch closes when end of air
blade engages bar C.
4. Maximum opening of air switch must be no greater
than 3/4 (20 mm) (figure 3). Bend tab F in or out
to maintain this dimension.
5. Re-install air switch assembly on rear of dryer.
6. Re-check operation of air blade. Switch must close
before air blade engages face of opening and re-
open before stop F engages.
AIR SWITCH
ADJUSTMENT
Summary of Contents for HD150.1
