45
Catalyst 6500 Series Power over Ethernet Daughter Cards Field-Upgrade Installation Note
78-10826-08
Installing the Ethernet Switching Module
c.
Using the thumb and forefinger of each hand, grasp the two ejector levers and exert a slight pressure
to the left, deflecting it approximately 0.040 inches (1 mm) creating a small gap between the
module’s EMI gasket and the module adjacent to it. (See
Figure 39
.)
Caution
Do not exert too much pressure on the ejector levers because they will bend and get damaged.
d.
While pressing down on the ejector levers, simultaneously close the levers to fully seat the module
in the backplane connector. The ejector levers are fully closed when they are flush with the module
faceplate. (See
Figure 40
.)
e.
Tighten the two captive installation screws on the module.
Note
Make sure that the ejector levers are fully closed before tightening the captive installation
screws.
f.
Verify that the module STATUS LED is lit. Periodically check the STATUS LED. If the STATUS
LED changes from orange to green, the module has successfully completed the boot process and is
now online. If the STATUS LED remains orange or turns red, the module has not successfully
completed the boot process and may have encountered an error.
Figure 40
Closing the Ejector Levers in a Vertical Slot Chassis
FAN
STATUS
SUPERVISO
R2
WS-X6K-SU
P2-2GE
STATUS
SYSTEM
CONSOLE
PWR MGMT
RESET
CONSOLE
CONSOLE
PORT
MODE
PCMCIA
EJECT
PORT 1
PORT 2
Switch Loa
d
100%
1%
SUPERVISOR2
WS-X6K-SUP2-2GE
STATUS
SYSTEM
CONSOLE
PWR MGMT
RESET
CONSOLE
CONSOLE
PORT
MODE
PCMCIA
EJECT
PORT 1
PORT 2
Switch Load
100%
1%
91119
All ejector levers flush
with module faceplate
48 PORT
10/100 BASE-T
ETHERNET SW
ITCHING
MODULE
WS-X6148-RJ-
45
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
1
2
12
14
24
26
36
38
48
