31
Catalyst 6500 Series Power over Ethernet Daughter Cards Field-Upgrade Installation Note
78-10826-08
Removing and Installing the WS-F6K-FE48X2-AF Inline-Power Daughter Card
Step 4
Carefully remove the inline-power daughter card from the module and set it on an antistatic mat or
antistatic foam.
Step 5
If you are installing a replacement WS-F6K-FE48X2-AF inline-power daughter card, go to the
“Installing the WS-F6K-FE48X2-AF Inline-Power Daughter Card” section on page 31
. If you are
installing the Ethernet module back into the chassis, go to the
“Installing the Ethernet Switching
Module” section on page 39
.
Installing the WS-F6K-FE48X2-AF Inline-Power Daughter Card
To install the WS-F6K-FE48X2-AF inline-power daughter card on the module, perform these steps:
Step 1
Position the inline-power daughter card over the module and carefully align the two threaded studs on
the module with the corresponding holes in the inline-power daughter card. (See
Figure 24
.) This step
aligns the inline-power daughter card connectors with the module connectors.
Figure 24
Positioning the Inline-Power Daughter Card Over the Module (WS-F6K-FE48X2-AF)
113435
Daughter card
