21
Catalyst 6500 Series Power over Ethernet Daughter Cards Field-Upgrade Installation Note
78-10826-08
Removing and Installing the WS-F6K-VPWR-GE Inline-Power Daughter Card
Step 4
Carefully remove the inline-power daughter card from the Ethernet module and set it on an antistatic mat
or antistatic foam.
Step 5
If you are installing a replacement WS-F6K-VPWR-GE inline-power daughter card, go to the
“Installing
the WS-F6K-VPWR-GE Inline-Power Daughter Card” section on page 21
. If you are installing the
Ethernet module back into the chassis, go to the
“Installing the Ethernet Switching Module” section on
page 39
.
Installing the WS-F6K-VPWR-GE Inline-Power Daughter Card
To install the WS-F6K-VPWR-GE inline-power daughter card on the module, perform these steps:
Step 1
Position the inline-power daughter card over the module and carefully align the three threaded studs on
the module with the corresponding holes in the inline-power daughter card. (See
Figure 10
.). This step
aligns the inline-power daughter card front and rear connectors with the module front and rear
connectors.
Figure 10
Positioning the Inline-Power Daughter Card Over the Module (WS-F6K-VPWR-GE)
97380
Daughter card
