Installing the Cisco TS MSE 8710
6
ii
Open both retaining latches on the front of the blade or blanking blade.
When open, a retaining latch is at a 90° angle perpendicular to the front of
the blade.
iii Slide out the blade or blanking blade.
2
Open both retaining latches on the front of the Cisco TS MSE 8710. When
open, a retaining latch is at a 90° angle perpendicular to the front of the blade.
3
Slide the Cisco TS MSE 8710 into the blade slot (as shown in Figure 2) until it
stops.
4
Simultaneously close both retaining latches on the blade (thereby engaging the
connectors at the rear of the blade) to secure it in the chassis as shown in
Figure 3.
5
Using a No. 1 Phillips screwdriver, tighten the screws in the retaining latches
with a clockwise quarter turn.
The power is connected automatically as soon as you close the latches. The LCD
panel displays messages as parts are checked and eventually you see “Waiting for
application to boot” after which the Cisco logo appears followed by the IP address
allocated to the Cisco TS MSE 8710.
Figure 2: Inserting a blade into the chassis
