Multichannel STM-1 Port Adapter for the Cisco 7500 Series Router
tug-2 e1 national bits
41
12.0(14)S
tug-2 e1 national bits
To set the national reserved bits on an E1 line that has been mapped to a TUG-3, use the
tug-2 e1 national bits
configuration controller tug-3 command.
To set the national reserved bits an E1 line that has been mapped to an AU-3, use the
tug-2 e1 national bits
configuration controller au-3 command.
tug-2
tug-2 number
e1
e1-number
national bits
pattern
Syntax Description
Defaults
0x1F
Command Modes
Configuration controller tug3 (for an E1 line mapped to a TUG-3)
Configuration controller au3 (for an E1 line mapped to an AU-3)
Command History
Usage Guidelines
Use the
tug-2 e1 national bits
command in configuration controller tug3 command mode to configure
the national reserved bits for an E1 line that has been mapped to a TUG-3 via the
aug-mapping au-4
command.
Use the
tug-2 e1 national bits
command in configuration controller au3 command mode to configure
the national reserved bits for an E1 line that has been mapped to an AU-3 via the
aug-mapping au-3
command.
Examples
The following example configures the national reserved bits for E1 line 1, that has been mapped to a
TUG-3, into a 0x0 hexadecimal pattern:
Router(config)# controller sonet 2/0/0
Router(config-controller)# aug mapping au-4
Router(config-controller)# au-4 1 tug-3 2
Router(config-ctrlr-tug3)# tug-2 4 e1 1 national bits 0x0
The following example configures the national reserved bits for E1 line 1, that has been mapped to an
AU-3, into decimal pattern 0:
Router(config)# controller sonet 2/0/0
Router(config-controller)# aug mapping au-3
Router(config-controller)# au-3 1
Router(config-ctrlr-au3)# tug-2 4 e1 1 national bits 0
tug-2 number
A number in the range of 1 to 7.
e1-number
A number in the range of 1 to 3.
pattern
The national reserved bit pattern is a hexadecimal value in the range
0x0-0x1F (hexadecimal) or 0-31 (decimal).
Release
Modification
12.0(14)S
This command was introduced.
