Chapter 5 Hardware Diagnostic Tests
Running Power Supply Tests
5-8
Cisco SFS 7000P Hardware Installation Guide
OL-9167-01 Rev. A0
Enter the
show power-supply
command.
SFS-7000P#
show power-supply
=====================================================================
Power-supply Information
=====================================================================
ps type admin-status oper-status utilization voltage
---------------------------------------------------------------------
1 AC up up n/a 48
2 AC up up 15 47
Step 2
Specify the type of test (self-test is chosen by default) by entering the
diag
power-supply
id
command.
SFS-7000P>
enable
SFS-7000P#
config
SFS-7000P(config)#
diag power-supply 2
SFS-7000P(config-diag-power-supply-2)#
test self-test
Step 3
Start the test.
SFS-7000P(config-diag-power-supply-2)#
start
Step 4
Display the progress of the test by entering the
show diag fan
command.
SFS-7000P(config-diag-power-supply-2)#
exit
SFS-7000P(config)#
exit
SFS-7000P#
show diagnostic power-supply
======================================================================
Diagnostic Tests For Power Supply
======================================================================
module-type : power-supply
module-number : 2
test : self-test
iterations : 1
action : start
result : success
percentage-completed : 100
result-string : Power Supply Self Test Completed, Final
report : Passed=1, Failed=0, Total=1
Step 5
Display any errors that appear in the result string by entering the
show diag
fru-error
command.
SFS-7000P#
show diag fru-error
================================================================
Fru-Error
================================================================
Summary of Contents for SFS 7000P
Page 4: ......
