3-6
Cisco SFS 3012R Multifabric Server Switch Hardware Installation Guide
OL-11187-01
Chapter 3 Installing and Removing Server Switch Field Replaceable Units (FRUs)
Installing an InfiniBand Switch Module
Step 8
Tighten the screws on either side of the switch module to secure it to the chassis.
Figure 3-5
Securing an InfiniBand Switch Module
Step 9
Verify that the system image on the InfiniBand switch module is consistent with the image on other cards
in the chassis and update the image, if necessary. Use the
show card
command to determine the current
image, as shown in the following example:
SFS-3012R#
show card all
================================================================================
Card Information
================================================================================
admin
oper
admin
oper
oper
slot type
type
status
status
code
--------------------------------------------------------------------------------
1* controller
controller
up
up
normal
7 fc2port2G
fc2port2G
up
up
normal
8 fc2port2G
fc2port2G
up
up
normal
14 controller
controller
up
up
standby
15
ib12port4x
ib12port4x
up
down
wrong-image
16
ib12port4x
ib12port4x
up
up
normal
================================================================================
Card Boot Information
================================================================================Pr
boot
boot
boot
slot stage
status
image
--------------------------------------------------------------------------------
1
done
success TopspinOS-2.8.0/build068
7
done
success TopspinOS-2.8.0/build068
8
done
success TopspinOS-2.8.0/build068
14
done
success TopspinOS-2.8.0/build068
15
none
none
TopspinOS-2.8.0/build060
16
done
success
TopspinOS-2.8.0/build068
SFS-3012R#
To interpret the output, examine the information for the slot in which you just installed the InfiniBand
switch module. If the oper status is shown as “down” and the oper-code as “wrong-image” (as shown for
slot 15 in the example), then the module needs to have its image updated.
See
Chapter 4, “Viewing and Updating the Software Image”
for instructions about updating the software
image on the InfiniBand switch module.
180744
