2-10
Cisco SFS 3012R Multifabric Server Switch Hardware Installation Guide
OL-11187-01
Chapter 2 Installing and Booting the Cisco SFS 3012R Server Switch
Connecting InfiniBand Hosts
Step 4
Enter the
interface mgmt-ethernet
command.
SFS-3012R(config)#
interface mgmt-ethernet
Step 5
Enter the
addr-option dhcp
command to configure the chassis to obtain the IP address from the DHCP
server.
SFS-3012R(config-if-mgmt-ethernet)#
addr-option dhcp
Step 6
Enable the management port with the
no shutdown
command.
SFS-3012R(config-if-mgmt-ethernet)#
no shutdown
Step 7
Save the configuration to preserve it between reboots.
SFS-3012R(config-if-mgmt-ethernet)#
exit
SFS-3012R(config)#
exit
SFS-3012R#
copy running-config startup-config
Step 8
Enter the
show interface mgmt-ethernet
command to determine your IP address, as shown in the
following example:
SFS-3012R#
show interface mgmt-ethernet
================================================================================
Mgmt-Ethernet Information
================================================================================
mac-address : 00:05:ad:00:1e:1c
auto-negotiate : enabled
admin-status : up
oper-status : up
ip-addr : 172.29.230.60
mask : 255.255.0.0
gateway-addr : 172.29.230.1
addr-option : static
You can now establish a Telent session to your Cisco SFS 3012R Server Switch or enter the IP address
of your Cisco SFS 3012R Server Switch in a web browser to launch Chassis Manager.
Connecting InfiniBand Hosts
This section provides a brief overview for connecting your InfiniBand hosts. For detailed instructions,
see the documentation for the specific Host Channel Adapter
(HCA).
Use InfiniBand cables to connect the HCA in your host to the InfiniBand switch module of your
Cisco SFS 3012R Server Switch. To plug in an InfiniBand cable, push the connector into the interface
until you hear and feel a click. See
Figure 2-5
and
Figure 2-6
.
