Cisco REN301, User Manual

Page: 38 / 92

Chapter 2 Installing the Residential Gateway
14 4038767 Rev A
Follow these instructions:
1 Determine where you want to mount the residential gateway. Make sure that the
wall you use is smooth, flat, dry, and sturdy. Also make sure the location is
within reach of an electrical outlet.
2 Drill two holes into the wall. Make sure the holes are 4 inches (101.6 mm) apart.
3 Insert a screw into each hole and leave 2 mm (0.8 inches) below the head
exposed.
4
Maneuver the residential gateway so two of the wall-mount slots line up with
the two screws.
5 Place the wall-mount slots over the screws and slide the residential gateway
down until the screws fit snugly into the wall-mount slots.