Chapter 4 Connecting the Cisco RPS
Connecting Hubs
4-2
Cisco Redundant Power System Hardware Installation Guide
OL-3654-01
Warning
Attach only the Cisco RPS (model PWR600-AC-RPS) to the RPS receptacle. To
see translations of the warnings that appear in this publication, refer to the
Regulatory Compliance and Safety Information
document that accompanied this
device.
Warning
Before performing any of the following procedures, ensure that power is
removed from the DC circuit. To ensure that all power is OFF, locate the circuit
breaker on the panel board that services the DC circuit, switch the circuit
breaker to the OFF position, and tape the switch handle of the circuit breaker in
the OFF position. To see translations of the warnings that appear in this
publication, refer to the
Regulatory Compliance and Safety Information
document that accompanied this device.
Warning
Before working on a system that has an on/off switch, turn OFF the power and
unplug the power cord. To see translations of the warnings that appear in this
publication, refer to the
Regulatory Compliance and Safety Information
document that accompanied this device.
Warning
This unit might have more than one power cord. To reduce the risk of electric
shock, disconnect the two power supply cords before servicing the unit. To see
translations of the warnings that appear in this publication, refer to the
Regulatory Compliance and Safety Information
document that accompanied this
device.
Connecting Hubs
This section provides illustrations and cabling information for connecting the
Cisco RPS to the following hubs:
•
Cisco 1516M hub (HP 10BASE-T Hub-16M) (
Figure 4-1
)
•
FastHub 400 series hubs (
Figure 4-2
)
