C
ASSATT
A
CTIVE
R
ESPONSE
C
ONTROL
N
ODE
AND
N
ETWORK
S
WITCH
C
ABLING
E
XAMPLE
23
3. If the switch was used previously in a switch stack, and is now in a different switch stack,
it may have a switch number other than 1 and 2. To determine if the switch number must
be reset, display the switch configuration as follows:
Current
Switch# Role Mac Address Priority State
--------------------------------------------------------
*1 Master 0011.bb7e.9480 1 Ready
2 Slave 0011.bb25.ce80 1 Ready
Current
Switch# Role Mac Address Priority State
--------------------------------------------------------
*1 Master 0011.bb7e.9480 1 Ready
2 Slave 0011.bb25.ce80 1 Ready
4. Enter the configuration mode, as follows:
Enter configuration commands, one per line. End with CNTL/Z.
5. Renumber the switch, as follows:
WARNING: Changing the switch number may result in lost
or changed configuration for that switch!
At this prompt...
Enter...
Notes
sw01#
show switch
Displays the following output:
If...
Then...
If a switch number other than 1 and 2 is
indicated in the output
Go to step 4.
If the switch number is 1 and 2
Go to step 7.
At this prompt...
Enter...
Notes
Switch#
configure terminal
Displays the following output:
At this prompt...
Enter...
Notes
sw01#
switch 3 renumber 2
Replace 3 with the number
displayed for your switch.
Replace 2 with the number that
is missing.
Displays the following output:
At this prompt...
Enter...
Notes
Do you want to continue?[confirm]
y
Displays the following output:
