Step 5
Pull the top hinge pin down on the door.
The bottom hinge pin is fixed.
Note
Step 6
Align the door hinges with the bracket hinges.
Step 7
Slide the bottom hinge pin into the bracket hinge and move the top hinge pin in the upward direction.
The ground strap cable is pre-installed on the door.
Note
Step 8
Connect the other end of the ground strap cable to a grounding point on the door bracket using a fastener.
Opening and Removing the Door of the NCS 4216 Shelf
This procedure opens and removes the door of the NCS 4216 shelf.
The NCS 4216 shelf has an ESD plug input and is shipped with an ESD wrist strap. The ESD plug input is
located on the outside of the shelf on the right side. It is labeled “ESD” on the top and bottom. Always wear
an ESD wrist strap and connect the strap to the ESD plug when working on the NCS shelf.
Note
To open and remove the door of the NCS 4216 router, follow the steps below:
Procedure
Step 1
Turn the knob to unlock the door.
Step 2
Swing the door open.
Step 3
Remove the ground cable from the shelf by removing the screw.
Step 4
Pull the top hinge pin holding the door to the chassis, in the downward direction.
Step 5
Lift the door out of the bottom hinge pin to remove the door from its hinges.
Installing the Patch Panel on the Rack
This procedure installs the Patch Panel on the Rack.
Procedure
Step 1
Assemble the patch panels on the opposite side of the rack to make the cable routing process easy.
Step 2
Fix one patch panel with a minimum of two screws on each side.
Installing the Cisco NCS 4216
16
Installing the Cisco NCS 4216
Opening and Removing the Door of the NCS 4216 Shelf
