Cisco LINKSYS WUSB300N, Manual

Page: 177 / 586

9 Chapter 4: Setting up and Connecting the Wireless-N USB Network Adapter
Setting up the Adapter
Wireless-N USB Network Adapter
• WPA2 Personal (Wi-Fi Protected Access 2)
If your network has the wireless security WPA2 Personal enabled, this screen will appear. You must enter
the same security settings used on your network.
Pre-shared Key - Enter a Pre-shared Key of 8-63 characters in the Pre-shared Key field.
Then click Connect and proceed to Step 3.
3. After the software has been successfully installed, the Congratulations screen will appear. Click Finish to
exit. For more information about the Wireless Network Monitor, refer to Chapter 5: Using the Wireless Network
Monitor .
Congratulations! The installation of the Wireless-N USB Network Adapter is complete.
To check the link information, search for available wireless networks, or make additional configuration changes,
proceed to “Chapter 5: Using the Wireless Network Monitor.”
Figure 4-7: WPA2 Personal Needed for Connection
Figure 4-8: Congratulations