![background image](http://html.mh-extra.com/html/cisco/linksys-ag310/linksys-ag310_user-manual_64946014.webp)
8
Chapter 4: Connecting the ADSL2+ Gateway with VoIP
ADSL2+ Gateway with VoIP
4. Connect an analog telephone to the Phone port on the Gateway’s back panel.
5. Connect one end of an Ethernet network cable to one of the Ethernet ports (labeled 1-4) on the back of the
Gateway, and the other end to an Ethernet port on a computer.
Repeat this step to connect more computers, a switch, or other network devices to the Gateway.
6. Connect the power adapter to the Gateway’s Power port, and then plug the power adapter into a power outlet.
The Power LED will immediately light up green. The Power LED will flash for a few seconds, and then it will be
solidly lit when the self-test is complete. If the LED flashes for one minute or longer, see “Appendix A:
Troubleshooting.”
7. Power on one of your computers that is connected to the Gateway.
NOTE:
You should always plug the Gateway’s power adapter into a power strip with
surge protection.
Figure 4-3: Connect a Phone
Figure 4-5: Connect the Power
Figure 4-4: Connect a PC