Cisco FM PONTE-50, Installation And Configuration Manual

Page: 78 / 132

IMPORTANT
For detailed information on the predefined rules for packet
management, refer to the
“Rules for packet management”
(page 79) table at the bottom of this section.
To connect the unit to a VLAN that is part of the local wireless network, do
the following steps:
1. Click the -vlan settings link under ADVANCED SETTINGS in the
left-hand settings menu.
• The VLAN SETTINGS dialog will be shown ( Figure 33
(page 78) ).
Figure 33. Configurator GUI (VLAN SETTINGS dialog)
2. Connect the unit to a VLAN that is part of the local wireless
network by checking the
ENABLE VLANs: check-box.
3. Enter the management identification number of the VLAN (used
to communicate with the device's operating system) in the
Management VLAN ID: field.
NOTE
The same Management VLAN ID number must be
used on all Cisco FM Ponte kit devices that are part
of the same bridge network.
4. Enter the native identification number (the VLAN ID implicitly
assigned to untagged packets received on trunk ports) in the
Native VLAN ID: field.
5. Save the VLAN settings by clicking the Save button. Alternatively,
clear the settings by clicking the Reset button.
Device configuration using the configurator interface
© 2021 Cisco and/or its affiliates. All rights reserved. Page 78 of 132