Figure 30. SNMP dialog (SNMP disabled)
NOTE
By default, Fluidmesh units are shipped from the
factory with SNMP disabled.
Using SNMP v2c
To change the unit's SNMP mode to
v2c
and configure the unit
accordingly, do the following steps:
1.
Click the
SNMP mode
drop-down, and click the
v2c
option.
• The
SNMP
v2c settings dialog will be shown (
).
Figure 31. SNMP dialog (v2c selected)
2.
Enter a community identity value in the
Community ID:
field.
IMPORTANT
The same community identity value must be set for
all Fluidmesh units in the wireless network.
Device configuration using the configurator interface
© 2021 Cisco and/or its affiliates. All rights reserved.
Page 74 of 132
