1-32
Cisco Flex 7500 Series Wireless Controller Installation Guide
Chapter 1 Cisco Flex 7500 Series Wireless Controller Installation Guide
Connecting and Using the CLI Console
Figure 1-10
Front of Cisco Flex 7500 Series Wireless Controller
Video
connector
USB 1
connector
USB 2
connector
255130
Figure 1-11
shows the locations of the input and output connectors on the rear of the server.
Figure 1-11
Rear of Cisco Flex 7500 Series Wireless Controller
282303
AC
DC
AC
DC
IMM 10/100 Mbps
Ethernet port
Service port HA port
Video
connector
Serial
connector
USB 3
connector
USB 5
connector
(Not used)
Power
connectors
10G port 1
10G port 2
USB 4
connector
Console port
(Not used)
Connecting and Using the CLI Console
For initial system configuration, use the command-line interface (CLI) console. The CLI console
connects to the controller back-panel DB9 console port.
Figure 1-6 on page 1-24
shows the console port
on the back panel of the controller. Back panel components are described in
Rear Panel Components,
page 1-24
.
Use these terminal emulator settings for the CLI console session:
•
9600 baud
•
8 data bits
•
no flow control
•
1 stop bit
•
no parity
Powering On the Controller
When you apply AC power to a controller, the bootup script initializes the operating system and its stored
configurations. You are prompted to enter a user ID and password and enter key configuration details.
Follow these steps to power up the controller.
