Cisco Firepower 1120, Hardware Installation

Page: 22 / 98

22
Router Hardware Description
Hardware Features
Cable Panel (Back Panel) Features
Figure 5 Cable Panel (Back Panel) Features
302210
RESET
SPD
EN
SFP 0/1
SPD
EN
SFP 0/0
GE 0/1 GE 0/0 FE 0/5 FE 0/4
FE 0/3 FE 0/2 FE 0/1 FE 0/0
ALARM
OUT 1
IN 4 IN 3 IN 2 IN 1
GPS WIFI AC
T SYS
ALARM
CONSOLE
PO
WER
PE N L3 L2 L1
+
-
1 5 6
7 8 9
2 3 4
Table 2 Cable Panel (Back Panel) Features
Item Feature Description
1 CONFIG Reset button Press for at least 5 seconds to return the router software configuration to the factory
default, and power cycle the router. For information on how to use this feature,
including a Caution statement, see the
CONFIG Reset Button, page 23 .
2 SFP ports Install supported small-form-factor pluggable (SFP) modules in these two SFP
ports, labeled ETH 2/1 and ETH 2/2. For more information and supported SFPs, see
the
Small Form-Factor Pluggable (SFP) Ports, page 24 .
3 Ethernet ports:

2–Gigabit Ethernet
(10/100/1000 Mbps)

6–Fast Ethernet
(10/100 Mbps)
Make network connections using the Ethernet ports. For more information, see the
Ethernet Ports, page 25 .

Gigabit Ethernet (GE) ports—GE ports ETH 2/1 and ETH 2/2 are WAN ports for
connectivity to a primary substation or a control center.

Fast Ethernet (FE) ports —FE ports ETH 2/3 to ETH2/8 are LAN ports for local
network devices.
4 Serial ports Connect the router to legacy devices using these two serial ports. For more
information on these ports and supported devices, see the
Serial Ports, page 27 .
5 Console port Connect a console or PC to the asynchronous console port to manage the router
with a local connection.
6 PWR RESET button Press the PWR RESET button for at least 5 seconds to power cycle the router. For
more information on how to use this feature, see the
PWR RESET Button, page 24 .