Cisco Firepower 1120, Hardware Installation

Page: 98 / 98

98
Power Connectors
For detailed information about the router power supply terminal connectors (AC and DC input terminals), see Router
Hardware Description, page 13 .
Cable and Adapter Specifications
SFP Cable
For detailed information about the SFP ports, see Router Hardware Description, page 13 .
7 Clear to send (CTS) <— —>
8 Request to send (RTS)
—>
<—
1
The RS232 pinouts use the EIA-561 standard.
Table 5 Serial Port Specification (continued)
RS-232
1
Pin Signal Description (Abbreviation) DTE DCE
Table 6 SFP Port Cabling Specification
SFP Module Wavelength
(nm) Cable
Type Core size/
Cladding Size
(micron) Modal
Bandwidth
(MHz/km) Cable Distance
1000BASE-SX 850 MMF 62.5/125 160 722 feet (220 m)
62.5/125 200 902 feet (275 m)
50/125 400 1640 feet (500 m)
50/125 500 1804 feet (550 m)
3281 ft (1000 m)
1000BASE-LX/LH 1310 MMF
1
62.5/125 500 1804 feet (550 m)
50/125 400 1804 feet (550 m)
50/125 500 1804 feet (550 m)
SMF G.6522 — 32,808 feet (10,000 km)
1000BASE-EX 1310 SMF — — 131,234 feet (40,000 km)
1000BASE-ZX 1550 SMF G.652
2
— 43.4 to 62 miles
(70 to 100 km)
2
1000BASE-BX-U 1310 SMF — — 32,808 ft (10,000 m)
1000BASE-BX-D 1490 SMF — — 32,808 ft (10,000 m)
1
A mode-conditioning patch cord is required. Using an ordinary patch cord with MMF or 1000BASE-LX/LH SFP
modules and a short link distance can cause transceiver saturation and an elevated bit error rate (BER). When using
the LX/LH SFP module with 62.5-micron diameter MMF, you must also install a mode-conditioning patch cord
between the SFP module and the MMF cable on both the sending and receiving ends of the link. The
mode-conditioning patch cord is required for link distances greater than 984 feet (300 m).
2
1000BASE-ZX SFP modules can send data up to 62 miles (100 km) by using dispersion-shifted SMF or
low-attenuation SMF; the distance depends on the fiber quality, the number of splices, and the connectors.