16
Installation and Configuration Note for the Cisco Catalyst 4500 E-Series Supervisor Engine 6L-E
OL-19334-02
Removing the Supervisor Engine
Figure 4
Installing the Supervisor Engine in the Chassis (Catalyst 4506-E Shown)
Step 7
Pivot the two module ejector levers out and away from the faceplate.
Step 8
Carefully slide the supervisor engine into the slot until the notches on both ejector levers engage the
chassis sides.
Step 9
Using the thumb and forefinger of each hand, simultaneously pivot in both ejector levers to fully seat the
supervisor engine in the backplane connector.
Caution
Always use the ejector levers when installing or removing a supervisor engine. A supervisor engine that
is partially seated in the backplane will not function correctly.
Step 10
Use a screwdriver to tighten the captive installation screws on each end of the supervisor engine
faceplate.
To check the status of the module, follow these steps:
Step 1
Ensure that the LED labeled Status is green (module operational).
Step 2
When the switch is online, enter the
show module
command. Verify that the system acknowledges the
new module and that the module’s status is good.
Step 3
If the module is not operational, reseat it. If the module is still not operational, contact your customer
service representative.
274485
4506
WS-X45-Sup
6L-E
