9
Installation and Configuration Note for the Cisco Catalyst 4500 E-Series Supervisor Engine 6L-E
OL-19334-02
Supervisor Engine 6L-E
•
Protocol filtering on a per-port basis
•
Dynamic protocol filtering
•
Support for IEEE 802.3x flow control
•
Hardware-based multicast
•
Hardware-based access lists
•
Supervisor engine redundancy between primary and standby supervisor engines in Catalyst 4507R
and Catalyst 4507R-E switches
•
802.1Q tunneling
•
Storm control in hardware
Features of the Supervisor Engine Front Panel
The following sections describe the LEDs, connectors, and switches on the Catalyst 4500 E-series
Supervisor Engine 6L-E:
•
LEDs, page 9
•
10-Gigabit Ethernet Uplink Ports, page 10
•
Gigabit Ethernet SFP Uplink Ports, page 10
•
Ethernet Management Port, page 10
•
Console Port, page 12
•
Reset Button, page 12
•
Compact Flash Port, page 12
LEDs
Table 1
describes the LEDs on the supervisor engine front panel.
Table 1
Supervisor Engine LEDs (WS-X45-SUP6L-E)
LED
LED Status
Description
STATUS
Indicates the results of a series of self-tests.
Green
All diagnostic tests passed.
Red
A test failed.
Orange
System boot or diagnostic test is in progress.
Off
Module is disabled.
UTILIZATION
Green 1–100%
If the switch is operational, this display indicates the current
traffic load over the backplane (as an approximate percentage).
