2-25
Catalyst 3750-X and 3560-X Switch Hardware Installation Guide
OL-19593-01
Chapter 2 Switch Installation
Installing SFP and SFP+ Modules
Figure 2-25
Installing the Network Module in the Switch
Caution
Do not install the converter module with connected SFP modules or cables. Always remove any cables
and modules before installing the converter module in the slot.
Removing a Network Module
Step 1
Attach an ESD-preventive wrist strap to your wrist and to a bare metal surface.
Caution
Do not remove the network module with installed SFP modules or cables. Always remove any cables
and modules before removing the network module from the slot.
Step 2
Disconnect the cables from the SFP module.
Step 3
Remove the SFP modules from the network module.
Step 4
Loosen the captive screws that hold the network module in place.
Step 5
Carefully press the tab on the right side of the network module to release it from the slot. Grasp the edges
of the module, and carefully slide it out of the slot.
Step 6
Install a replacement network module or a blank module in the slot.
Step 7
Place the module that you removed in an antistatic bag or other protective environment.
Installing SFP and SFP+ Modules
This section describes how to install and remove SFP modules in the network module.You must have a
network module installed in the switch to use SFP modules.
See the
“SFP and SFP+ Modules” section on page 1-5
and the switch release notes on Cisco.com for the
list of SFP modules that the switch supports. Use only Cisco SFP modules on the switch.
For more information about installing, removing, cabling, and troubleshooting SFP modules, see the
module documentation that shipped with your device. For module cable specifications, see
Appendix B,
“Connector and Cable Specifications.”
253156
3
7
38
3
9
4
5
6
7
8
9
10
11
12
C
3
KX-NM-10G
NETW
ORK
MODULE
G1
G2/TE1
G
3
G4/TE2
