1-14
Cisco 3200 Series Router Hardware Reference
OL-5816-10
Chapter 1 Cisco 3200 Rugged Enclosures
To attach the protective end cap cover to the enclosure, follow these steps (see
Figure 1-10
).
Figure 1-10
Protective End Cap Cover Installation
Step 1
Loosen the end cap mounting hardware (four 1/4-20 bolts), but do not remove the bolts.
Step 2
Slide the hinge brackets onto the right side and the left side of the end cap cover. The mounting tabs
should slide under the loosened bolts.
Step 3
Re-torque the two loosened bolts on the right side of the end cap cover to between 58 and 68 in-lb.
Step 4
Ensure that the gasket is fully seated in the protective end cap cover.
Step 5
Close the cover on the protective end cap cover and ensure that it is fully seated.
Step 6
Re-torque the end cap cover bolts on left side of the end cap cover to between 58 and 68 in-lb.
Step 7
Tighten the 8-32 protective cover screws (18 in-lb) until they are seated.
For sealing, we recommend Liquid Tight Connector, which is described at the following URL:
http://www.newark.com/NewarkWebCommerce/newark/en_US/mfr/brands.jsp?mfg=HUBB
1
Hinge bracket
2
Hinge point
3
Cable/service loop cavity
4
NEC pass-through
5
Gasket
6
Cap mounting
170106
1
2
3
6
4
5
