2-26
Cisco BBSM Hotspot 1.0 User Guide
78-15293-01
Chapter 2 Setting Up BBSM Hotspot
Configuring Windows for Multinet
Step 7
Click
Submit
. A confirmation window appears.
Step 8
Click
Close
.
Configuring Windows for Multinet
This section describes how to configure the Windows operating system to support multiple networks
(multinets), on the BBSM Hotspot server. You only need to perform this procedure if you are using a
multinet. BBSM Hotspot servers are initially configured as single networks, or singlenets.
Note
For more information on multinets, refer to the
“Private and Public IP Addresses (Multinet)” section on
page 2-40
.
Caution
Although you use the Network and Dial-up Connections window to add multinet 2, do not delete
multinet 2 through this window, because although it is deleted from the GUI, it does not actually get
removed from the BBSM Hotspot databases. Use the Address Change Wizard to remove multinet 2.
Refer to the
“Running the Address Change Wizard” section on page A-1
.
Use the following procedure to reconfigure the internal NIC on your BBSM Hotspot server.
Step 1
Right-click
My Network Places
.
Step 2
From the pop-up menu, select
Properties
. The Network and Dial-up Connections window appears.
(See
Figure 2-26
.)
Figure 2-26 Network and Dial-up Connections Window
Step 3
Right-click
AtNatMP
, and select
Properties
. The AtNatMP Properties window appears.
(See
Figure 2-27
.)
