If an accessory grill is installed on the front of the Cisco ASR 9010 Router, remove the grill by pulling it
towards you until it comes loose. See
Installing Base Chassis Accessories on the Cisco ASR 9010 Router, on
and
Figure 136: Installing Base Chassis Accessories on the Cisco ASR 9010 Router, on page 127
for
information.
Note
If a fan tray cover is installed on the front of the Cisco ASR 9922 Router, remove the fan tray cover by pulling
on the cover until it comes loose. See
Removing a Fan Tray from the Cisco ASR 9010 Router, Cisco 9910
Router, Cisco ASR 9922 Router, and Cisco ASR 9912 Router, on page 74
for more information.
Note
On the Cisco ASR 9922 Router, the third and fourth fan trays (under the middle cage) are installed upside
down compared to the first and second fan trays (above the middle cage).
Note
Procedure
Step 1
Loosen the captive screw on each side of the fan tray.
Step 2
Using the handle on the front panel, pull the fan tray halfway out of the chassis.
Wait a few seconds for all the fans to stop rotating before lifting the fan tray from the chassis.
Note
Step 3
Slide out the fan tray completely from the chassis while supporting it with your other hand.
Use two hands when handling the fan tray. Each version 1 fan tray weighs about 16 pounds (7.27
kg). Each version 2 fan tray weighs about 18 pounds (8.18 kg).
Caution
Figure 78: Removing or Installing the Fan Tray on the Cisco ASR 9010 Router Chassis
Cisco ASR 9000 Series Aggregation Services Router Hardware Installation Guide
75
Unpacking and Installing the Chassis
Removing a Fan Tray from the Cisco ASR 9010 Router, Cisco 9910 Router, Cisco ASR 9922 Router, and Cisco ASR 9912 Router
