3-14
Cisco Aironet 1250 Series Access Point Hardware Installation Guide
OL-8247-03
Chapter 3 Troubleshooting 1250 Series Autonomous Access Points
Low Power Condition on Autonomous Access Points
Table 3-5
and
Table 3-6
lists the access point system power settings and the Cisco switch power
commands for several power options.
Table 3-5
System Power Settings and Cisco Switch Commands for Access Points with a Single Radio Module
Power Source
Access Point System Power Settings
Cisco Switch
Power Command
AC power module
Configuration changes are not required
power inline never
Cisco switch that supports
Intelligent Power Management
1
1.
You should check the release notes for your Cisco power source to determine which Cisco IOS release supports Intelligent Power Management. Support
for Intelligent Power Management might not be currently available for your Cisco power source.
Power Settings:
Power Negotiation
(selected)
Power Injector:
Installed on Port with MAC Address
(unchecked)
power inline auto
Cisco switch that does not
support Intelligent Power
Management
1
Power Settings:
Pre-standard Compatibility
(selected)
Power Injector:
Installed on Port with MAC Address
(unchecked)
power inline auto
Power injector
2
used with a
Cisco switch that supports
Intelligent Power Management
1
2.
Power injector must be AIR-PWRINJ4.
Power Settings:
Power Negotiation
(selected)
Power Injector:
Installed on Port with MAC Address
(unchecked)
power inline never
Power injector
2
used with a
Cisco switch that does not
support Intelligent Power
Management
1
Power Settings:
Power Negotiation
(selected)
Power Injector:
Installed on Port with MAC Address
(checked)
power inline never
Power injector used with a
non-Cisco switch
Configuration changes are not required
–