1-24
Cisco SRST SNMP MIB Release 3.4 Guide
OL-7959-01
Chapter 1 Cisco SRST SNMP MIB Support
Configuration
Step 2
Issue the following CLI command:
Show voice register pool <pool #>
Step 3
Verify the
show voice register
response is similar to the following:
SRST-Router#sh voice regi pool 1
Pool Tag 1
Config:
Network address is 1.4.196.0, Mask is 255.255.255.0
Proxy Ip address is 1.4.196.1
DTMF Relay is disabled
Dialpeers created:
dial-peer voice 40001 voip
destination-pattern 5001
redirect ip2ip
session target ipv4:1.4.196.41:25672
session protocol sipv2
dial-peer voice 40002 voip
destination-pattern 5001
redirect ip2ip
session target ipv4:1.4.196.1:5060
session protocol sipv2
monitor probe rtr 1.4.196.1
dial-peer voice 40003 voip
destination-pattern 5002
redirect ip2ip
session target ipv4:1.4.196.41:25672
session protocol sipv2
dial-peer voice 40004 voip
destination-pattern 5002
redirect ip2ip
session target ipv4:1.4.196.1:5060
session protocol sipv2
monitor probe rtr 1.4.196.1
Statistics:
Active registrations : 4
Total Registration Statistics
Registration requests : 4
Registration success : 4
Registration failed : 0
unRegister requests : 0
unRegister success : 0
unRegister failed : 0
Step 4
Issue the following SNMP request:
Getmany -v2c <ip addr> test csrstSipEndpointTable
Step 5
Verify the response for the
getmany
request is similar to the following:
moki:1919> getmany -v2c 1.4.196.1 test csrstSipEndpointTable
csrstSipVoRegPoolEdptTag.0 = 1
csrstSipVoRegPoolEdptTag.1 = 1
csrstSipVoRegPoolEdptTag.2 = 1
csrstSipVoRegPoolEdptTag.3 = 1
csrstSipEndpointIpAddrType.0 = ipv4(1)
csrstSipEndpointIpAddrType.1 = ipv4(1)