11
Step 3
Insert the hooks into the slots and then rotate the top
of the Cisco Unified IP Phone Expansion Module 7916
into the support bar so that it rests flush with the bar.
Step 4
Tighten the thumbscrew on the back of the
Cisco Unified IP Phone Expansion Module 7916.
Note
If you are installing two Expansion Modules,
repeat Steps 2, 3, and 4 for the second
Expansion Module.
Connect the Interface Cable
Refer to the following table, which depicts the “in” and “out”
icons on the AUX jacks, and to Figure 5 and the steps that
follow.
Figure 5
“In” and “Out” Icons on the AUX Jacks
In icon
Out icon
Step 1
Plug one end of the interface cable into the jack labeled
AUX on the Cisco Unified IP Phone.
Step 2
Plug the other end of the interface cable into the AUX
jack with the “in” icon underneath on the
Cisco Unified IP Phone Expansion Module 7916.
Note
If you are installing a
second
Cisco Unified
IP Phone Expansion Module 7916, continue
with Steps
3
and
4
. Otherwise go to the
“Connect the Power Supply Unit” section on
page 12.
Summary of Contents for 7916
Page 26: ...26 ...