6
Secure the Spacers
Install the Hardware
53380
A
B
C
Step 1
Loosen the 10-32 x 5/8-inch LG Phillips
pan-head screw at the end of the ledge of
the right-side bracket. This screw is the
anchor for the spanner bar.
Step 2
Remove the tape that secures the spanner
bar on the left bracket, and swing the bar
down (see A) over the anchor screw on the
opposite bracket.
Step 3
If the spanner bar does not reach the
opposite bracket, loosen the pan-head
screws to allow more play between the
brackets.
Step 4
Repeat Step 1 through Step 3 to fasten the
remaining spanner bar to its anchor screw.
(See C.)
Step 5
Push the brackets as far apart as possible
before tightening the screws.
Step 6
Use a Number 2 Phillips screwdriver to
tighten the six pan-head screws that
secure the brackets to the rack-mounting
posts, and the two anchor screws that
secure the spanner bars. (See B.)
Step 7
Adjust the brackets if the distance
between them is less than 17.5 inches
(44.45 cm).
