43
Cisco 6130 NI-1 to NI-2 Upgrade Kit Conversion Procedures
78-10709-03
Cisco 6130 NI-1 to NI-2 Conversion Procedures
Caution
Installing the cards in the chassis with the power leads reversed can damage the cards.
Warning
The power supply circuitry for the Cisco DSLAM equipment can constitute an energy
hazard. Before you install or replace the equipment, remove all jewelry (including rings,
necklaces, and watches). Metal objects can come into contact with exposed power
supply wiring or circuitry inside the DSLAM equipment. This could cause the metal
objects to heat up and cause serious burns or weld the metal object to the equipment.
Warning
Do not reach into a vacant slot or chassis while you install or remove a line card or a
fan. Exposed circuitry could constitute an energy hazard.
Note
All cards must be fully seated in the chassis. A push on the faceplate of each card is
required for the card to be fully seated.
Complete the following steps to install the NI-2 card in the Cisco 6130. It is important that you
accomplish each step completely before moving on to the next step.
Step 1
Inspect the NI-2 card. Verify that the daughterboard is fully seated on the main board.
Step 2
Verify that slots 10 and 11 of the Cisco 6130 have no bent pins.
Step 3
Vertically align the card edge with the card guides at the top and bottom of slot 10 on the Cisco 6130.
Step 4
Lift up on the ejector tabs and gently apply pressure to the bottom of the faceplate while pushing the
card into the slot.
Step 5
Push on the faceplate of each card to fully seat the card.
Step 6
Press down on the ejector tabs to secure the card and connect it to the backplane.
Step 7
Lock both NI-2 card locking tabs.
Use a flat-head screwdriver to turn the locking tab so that it overlaps the NI-2 card to prevent inadvertent
dislodging, as shown in Figure 20.
Figure 20
Locking the NI-2 Card
Locked
position
Unlocked
position
27035
