19
Cisco 6130 NI-1 to NI-2 Upgrade Kit Conversion Procedures
78-10709-03
Cisco 6130 NI-1 to NI-2 Conversion Procedures
Caution
During the software download, the boot ROM for the cards will be reprogrammed. Do not
remove any cards from the chassis during the software download. If cards are removed
from the chassis or loss of power occurs during this operation, the cards will lose the
ability to boot up and will require an RMA repair.
Caution
Do not remove a 4xflexi or a 4xSDSL line card from the Cisco 6130 chassis unless the
STATUS, ACTIVE, and four port LEDs are solid green. If line cards are removed from the
chassis before the LEDs are solid green, the line cards will lose the ability to boot up and
will require an RMA repair.
Step 4
The chassis may now be used to upgrade additional 4xflexi or 4xSDSL line cards from other NI-1
systems that are currently being converted to NI-2 systems. To program the line card’s boot ROM,
insert the line cards into the chassis and the new image will download.
Step 5
Remove the system controller card, 4xflexi line cards, and 4xSDSL line cards from the chassis.
a.
Lift up the ejector tab(s). This action disconnects the card from the backplane.
b.
Carefully slide the card out of the slot.
c.
Repeat for each xTU-C line card (if applicable) and the system controller card.
Note
To prevent damage to the cards that are removed from the chassis, place the cards
upright in a tray.
Remove the Power
The system should not be powered while you install and connect the Cisco 6130 system
hardware components.
Remove power to the system with one of the following methods:
•
Remove the fuses from the fuse and alarm panel
•
Turn off the breakers in the fuse and alarm panel
