1-4
Cisco Video Surveillance 6000P IP Camera Installation Guide
OL-28118-01
Chapter 1 Overview
IP Camera Physical Details
General Purpose I/O Terminal Block
Figure 1-3
shows the pin locations and descriptions.
Figure 1-3
GPIO Terminal Block Pin Locations and Descriptions
9
Recessed reset button
Recessed button that reboots the IP camera or resets it to a
default state. You can use a pin or paper clip to depress it.
Depending on how long you depress the recessed reset button,
you can do either of the following:
•
Reset—Press and release the recessed reset button. Wait for
the IP Camera to reboot.
•
Restore—Press and hold the recessed reset button until the
status LED rapidly blinks. All settings will be restored to
factory default. Upon successful restoration, the status
LED will blink green and red during normal operation.
10
Ethernet 10/100 RJ45 socket
Accepts a standard LAN cable to connect the IP camera to a
10/100BaseT router or switch.
11
Microphone switch
Switches the microphone operation between the following
options:
•
Internal (up)—Switches to the built-in internal microphone
on the IP camera
•
External (down)—Switches to the external Microphone In
connector
12
Video output switch
Switches the video output between to following standards:
•
NTSC 60Hz (up)—switches camera operation to the
National Television System Committee (NTSC) standard.
•
PAL 50Hz (down)—switches camera operation to the
Phase Alternating Line (PAL) standard.
13
Audio in
Audio input port for the IP camera.
Pin
Description
1
Power +12V
2
Digital Output
3
Digital Input
4
Ground
5
AC 24V Input
6
AC 24V Input
7
RS-485+
8
RS-485–
8
7
6
5
4
3
2
1
