Purpose
Command or Action
Example:
• Entering
no
exits the configuration session and
returns the router to EXEC mode without
committing the configuration changes.
RP/0/RP0/CPU0:router(config-dwdm)# commit
• Entering
cancel
leaves the router in the current
configuration session without exiting or
committing the configuration changes.
• Use the
commit
command to save the configuration
changes to the running configuration file and remain
within the configuration session.
Places the DWDM port in In Service (IS) state, to support
all normal operation.
admin-state in-service
Example:
Step 9
RP/0/RP0/CPU0:router(config-dwdm)# admin-state
in-service
Displays the G.709 Optical Transport Network (OTN)
protocol alarms and counters for Bit Errors, along with the
FEC statistics and threshold-based alerts.
show controllers dwdm interface-path-id g709
Example:
RP/0/RP0/CPU0:router# show controller dwdm 0/1/0/0
optics
Step 10
What to Do Next
All interface configuration tasks for the Gigabit Ethernet interfaces still must be performed in interface
configuration mode. Refer to the corresponding modules in this book for more information.
Configuring IPoDWDM
This section provides the following configuration procedures:
Configuring the Optical Layer DWDM Ports
Use the following procedure to configure the Optical Layer DWDM ports.
SUMMARY STEPS
1.
configure
2.
controller dwdm interface-path-id
3.
network port id id-number
4.
network connection id id-number
5.
Do one of the following:
•
end
•
•
commit
Interface and Hardware Component Configuration Guide for Cisco NCS 6000 Series Routers, IOS XR Release 6.4.x
135
Configuring Dense Wavelength Division Multiplexing Controllers
What to Do Next