Cisco 4G-ANTM-OM-CM, Manual

Page: 494 / 535

494
Cisco WPAN Yagi Antenna (ANT-WPAN-Y-OUT-N)
Preparing the Antenna for Installation
NOTE : Before mounting the antenna on a mast or pole, the antenna must be attached to the mounting bracket.
To prepare the antenna for installation:

Attach the bracket to the antenna support beam. Tighten the four nuts tight enough to stabilize the antenna. Torque to 45
in.-lbs. (5.1 N-m). The bracket should be toward the back of the antenna support beam.
Mounting the Antenna
Follow these instructions to mount the antenna.
1. Attach the antenna assembly to the pole using the two U-bolts provided. The antenna elements should be vertical for
vertical polarization.
2. Tighten the nuts evenly and enough to secure the antenna on the pole. Torque the nuts to 60 in.-lbs. (6.8 N-m).
3. Connect the RF cable to the pigtail and weatherproof the connection. Be sure to secure the cable to the pole using UV
resistant tie wraps.
Connecting the Lightning Arrestor
To attach the router-end of the cable to your router, see the Dual Antenna Advanced Range Extender—Dual Antenna
Configuration section of the Cisco IR500 Series WPAN Gateway and WPAN Range Extender Installation and Configuration
Guide .
Connecting the Antenna to the Router
To attach the router-end of the cable to your router, see the Dual Antenna Advanced Range Extender—Dual Antenna
Configuration section of the Cisco IR500 Series WPAN Gateway and WPAN Range Extender Installation and Configuration
Guide .
NOTE : Coaxial cable loses efficiency as the frequency increases, resulting in signal loss. The cable should be kept as short as
possible because cable length also determines the amount of signal loss—the longer the cable length or run, the greater the
loss).
Obtaining Documentation and Submitting a Service Request
For information on obtaining documentation, submitting a service request, and gathering additional information, see the monthly
What’s New in Cisco Product Documentation, which also lists all new and revised Cisco technical documentation, at:
http://www.cisco.com/en/US/docs/general/whatsnew/whatsnew.html
Subscribe to the What’s New in Cisco Product Documentation as an RSS (Really Simple Syndication) feed, and set it so content
is delivered directly to your desktop using a reader application. The RSS feeds are a free service and Cisco currently supports
RSS Version 2.0.
Cisco and the Cisco Logo are trademarks of Cisco Systems, Inc. and/or its affiliates in the U.S. and other countries. A listing of Cisco's trademarks can be found at
www.cisco.com/go/trademarks. Third party trademarks mentioned are the property of their respective owners. The use of the word partner does not imply a partnership relationship
between Cisco and any other company. (1005R)