Cisco 4G-ANTM-OM-CM, Manual

Page: 205 / 535

481
Cisco Aironet 2.4 GHz and 5 GHz Dual-Band Polarization-Diverse Directional Array Antenna (AIR-ANT2566D4M-R)
Obtain Documentation and Submit a Service Request
Figure 8 Elevation Adjustment
Mounting on a Pole or Mast
NOTE : The pole or mast must be rigid enough to hold the weight of an antenna along with the associated forces produced by
wind loads. In addition, the mast must be structurally strong enough to withstand the clamping force of the hose clamps.
1. Determine the mounting location for the antenna on the pole or mast.
2. Position and mount the mounting flange bracket on to the pole or mast using the hose clamps provided in the kit. The hose
clamps should pass through the slots on the free mounting flange bracket.
One of the two required articulating mount flange brackets come attached to the back of the antenna (see Figure 1 ). The other
flange bracket, included in the kit, is the one used in this step.
3. Tighten the hose clamps only to the extent that they can hold the flange bracket and the antenna in place until the antenna
is positioned at its final position. Use a slotted screwdriver to tighten the screws on the hose clamps.
4. Assemble the antenna and bracket to the flange bracket. See Figure 5 .
5. Position the antenna, mounting bracket, and hose clamps on the mast. See Figure 9 for reference.
6. Tighten the hose clamps until the antenna is fully secure on the mast. Ensure that the antenna cannot rotate about the mast.
353
8
99
55°
ADJUSTMENT
ELEVATION ADJUSTMENT
MAST