Cisco 3750 - Catalyst EMI Switch, Hardware Installation Manual

Page: 42 / 230

Chapter 1 Using Express Setup
Starting Express Setup
1-10
Catalyst 3750 Switch Hardware Installation Guide
78-15136-03
Note
For switches running Cisco IOS Release 12.2(18)SE or later, the
automatic medium-dependent interface crossover (Auto-MDIX) feature
enables the switch to detect the required cable type for copper Ethernet
connections and configures the interfaces accordingly. Therefore, you can
use either a crossover or a straight-through cable for connections to a
copper 10/100, 10/100/1000, or 1000BASE-T SFP module port on the
switch, regardless of the type of device on the other end of the connection.
The Auto-MDIX feature is enabled by default on switches running Cisco
IOS Release 12.2(18)SE or later.
If not, reconnect the straight-through cable to the Ethernet port on the switch
and PC or workstation. Wait 30 seconds before entering
10.0.0.1 in the
browser.
•
Did you verify that POST successfully ran before starting Express Setup?
If not, make sure that only the SYST and STAT LEDs are green before
pressing the Mode button to begin Express Setup.
Note
The rest of this chapter explains how to configure a switch by using the Express
Setup web page. To configure the switch by using the command-line interface
(CLI)-based setup program, see
Appendix C, “Configuring the Switch with the
CLI-Based Setup Program.”