Cisco 3750 - Catalyst EMI Switch, Hardware Installation Manual

Page: 39 / 230

1-7
Catalyst 3750 Switch Hardware Installation Guide
78-15136-03
Chapter 1 Using Express Setup
Starting Express Setup
Figure 1-5 Catalyst 3750-24PS and 3750-48PS Switch Mode Button
Step 3 Release the Mode button.
Note
If all of the LEDs begin to blink after you press the Mode button, release it.
Blinking LEDs mean that the switch has already been configured and cannot go
into Express Setup mode. For more information, see the
“Clearing the Switch IP
Address and Configuration” section on page 4-2 .
Step 4
Connect a straight-through Ethernet cable (not included) to an Ethernet port on
the front panel of the switch, as shown in
Figure 1-6 .
Caution
Do not connect the switch to any device other than the PC or workstation being
used to configure it.
1 Mode button
RPS
SYST
MASTR
STAT
DUPLX
SPEED
STACK
PoE
MODE
1
104760